Updated November 2026
This guide walks you through what it takes to get a dirt bike to ride well and safely, from checking the machine before you roll out to controlling it on a trail. By the end you will know the basic body position, the controls, and the habits that keep new riders out of trouble. Riding skill builds slowly, so treat these steps as a starting point and practice them in an open area first.
Check the Bike Before You Ride
Most beginner crashes start with a machine that was not ready. Before each ride, run through a short inspection so you know the bike is safe to start.
Shopping for one? See our guide: 4 Best Dirt Bike Gear Youth Picks for Kids' Safe Trail Rides (2026).
- Check tire pressure. Use the range printed on the tire sidewall or in the owner’s manual, and set it cold.
- Check chain slack. Look up the specified slack in the owner’s manual and adjust if needed.
- Test the brakes. Both levers and pedals should feel firm, with no sponginess.
- Check the throttle. It should snap back to idle as soon as you let go.
- Look at fluids and fasteners. Confirm oil and coolant levels, and check that the handlebar, axle and footpeg bolts are tight.
- Confirm the kill switch and clutch lever work as expected.
Learn the Riding Position and Controls
Your body position does more for control than almost anything else. Stand on the footpegs with your knees bent and gripping the tank, your elbows up and out, and your weight centered over the bike. Keep your head up and look well ahead to where you want to go, not at the front wheel.
Learn the controls in a parking lot or open field before you go anywhere near a trail. The right hand controls throttle and front brake, the left hand controls clutch, and your feet handle shifting and rear brake on most bikes. Practice pulling the clutch in and out smoothly, and use small, steady throttle inputs.
Starting, Shifting and Braking
Start in neutral with the clutch pulled in. Get the bike rolling by slowly releasing the clutch while adding a little throttle, then build speed in first gear. Shift up when the engine is pulling strongly and down before you slow for a turn. Braking is best done early and progressively: squeeze the front brake firmly and apply the rear brake gently at the same time. Grabbing the front brake hard can throw you over the bars.
Cornering and Staying Upright
Set Up for the Turn
Slow down before the corner, not in it. Look through the turn toward the exit, and let the bike lean under you while your body stays upright over the seat or pegs.
Keep Steady Throttle
Once you are leaned in, a small, even amount of throttle helps the bike hold its line. Abrupt closing or opening of the throttle mid-turn is a common cause of loss of control.
Common Mistakes to Avoid
- Staring at the front wheel instead of the path ahead.
- Riding too fast for your skill before you have learned to brake and corner.
- Skipping the pre-ride check and missing a loose bolt or low tire.
- Dropping the clutch too quickly, which stalls the engine or launches you forward.
- Riding without proper protective gear.
Recommended Gear
- A properly fitting helmet protects your head in a fall, the most important piece of gear you will wear. View on Amazon
- Over-the-ankle boots protect your feet and give you the support needed to hold the footpegs. View on Amazon
- Goggles keep dirt and debris out of your eyes so you can keep looking ahead. View on Amazon
For more on protective equipment, see Youth Protective Riding Gear: 6 Essentials for Safe ATV and Dirt Bike Rides and Winter Dirt Bike Riding Gear: 6 Essentials for Cold-Weather Trail Rides.
FAQ
How long does it take to learn to ride a dirt bike?
Most people can handle basic starting, stopping and turning within a few sessions in an open area. Confidence on varied terrain takes much longer and depends on how often you ride.
Should a beginner start on a big bike?
Usually not. A smaller, lighter machine is easier to control and lets you focus on technique. Check the manufacturer’s sizing guidance for the rider’s height and weight.
Do I need a license to ride a dirt bike?
Rules vary by state and by whether you ride on public or private land. Check your state’s motor vehicle and off-road regulations before riding on public trails.
Conclusion
Getting a dirt bike to ride well comes down to a sound pre-ride check, a balanced body position, and smooth control of the throttle, clutch and brakes. Practice these basics in a safe, open area before tackling trails. Consider a riding course or an experienced rider’s guidance as you progress.
